SANUS VuePoint FLF322 Manual De Instrucciones página 16

3
07
Drill pilot holes then remove the wall plate template
IMPORTANT: Be sure to drill into the center of the stud.
IMPORTANT: Pilot holes must be drilled to a depth of 2 ¾ in. (70 mm),
using a 7/32 in. (5.5 mm) diameter drill bit.
All manuals and user guides at all-guides.com
2¾ in. (70 mm)
7/32 in.
(5.5 mm)
.
07
4
10
09
08
Install the wall plate using four lag bolts
08
Tighten all lag bolts only until they are pulled firmly against the wall plate.
CAUTION:
Improper use could reduce the holding power of the
lag bolt. DO NOT over-tighten the lag bolts.
Go to STEP 3 on PAGE 16.
and washers .
09
10
13