Morso 6100 Manual De Instrucciones página 6

Fitting the fresh air system/air kit for the Morsø 6100 series
To fit the fresh air system/air kit you must first remove the external cast back panel.
1. Remove/lift off the top cast top panel which
is lying loose on the stove.
2. The top frame holds the side panels and
back panel in place on top of the stove. As it
can be difficult to hold both the side panels
and back panel without them falling out, we
recommend stretching some cord around
the stove as a precaution before removing
the top frame.
3. Remove the 4 screws in the cast top frame
and then the cast back panel.
6 7
4. Unscrew the angle fitting in the bottom of the
cast air duct on the back of the stove.
5. Unscrew the radiation shield at the bottom
of 6140.