First Use - Qlima ECO 1700 Instrucciones De Uso

2. WHAT TO DO IN THE EVENT OF AN EMERGENCY OR
FLUE FIRE (FIRE OUTSIDE THE COMBUSTION CHAMBER)
1.
2.
3.
4.
5.

3. FIRST USE

A qualified Qlima service technician must fire up the stove for the first time. Not
using a Qlima authorised technician could mean that local legislation is not for-
filled. Also will it lead to nihilation of the warranty of the stove. The first time the
stove is fired up, it must be adjusted to ensure the correct air/fuel ratio at each of
the five combustion levels. The correct ratio strongly depends on the type of flue
duct fitted and can only be set after the stove has been installed. An incorrect air/
fuel ratio can seriously damage the stove. The fuel consumption will also increase.
G
3.1 ACTIONS BEFORE AND DURING INITIAL START-UP
G
1.
2.
3.
4.
4
72
Turn the stove off immediately by removing the plug from the socket.
Put the fire in the stove out using a CO
minimise smoke emissions. Never use water to extinguish the fire.
In the event of a flue fire: Close the choke valve (refer to local/national rules,
regulations, directives and norms as to whether a choke valves is permitted)
or close off the flue with a wet cloth.
CAUTION: the flue can get very hot. When sealing, always wear heat-
resistant gloves.
Alert the fire brigade immediately.
Ventilate the room by opening all windows and doors due to the possible
build-up of carbon monoxide.
Never change the service parameters in the service menu. This may
seriously damage the stove and invalidate the warranty. The stove may
only be set up by a Qlima-approved service technician.
In the case of new build or refurbishment: allow the building to dry
out thoroughly before using the stove for the first time. It is well
understood that walls, ceilings and/or floors take a long time to dry
completely. Soot, ash particles etc. can easily stick to walls that have not
fully dried.
C heck whether the stove has been installed according to the installation
manual.
Remove all items such as the manual, stove tools etc. from in and around the
stove before putting it into operation.
Fill the pellet hopper with pellets. See section 5 of this manual, "Filling the
pellet hopper with pellets", for details about which pellets to use and how
to fill the hopper.
Put the plug into an earthed mains socket and turn the power switch on.
This is located at the rear of the stove.
extinguisher, sand, soda or salt to
2