Cleaning The Heat Exchanger - Qlima ECO 1700 Instrucciones De Uso

The glass is heat resistant but can crack due to rapid temperature changes. There-
fore allow the window to cool down completely before cleaning it. Use ordinary
glass-cleaning spray and cleaning cloths.
6.4 CLEANING THE BRAZIER AND ASH DRAWER
1.
2.
3.
4.
G
5.

6.5 CLEANING THE HEAT EXCHANGER

When the stove is switched off and cold:
1.
2.
3.
4.
5.
6.6 CHECK THE SEAL ON THE FIRE DOOR
Check the door seal for leaks and damage at least twice a year; the first time before
the season starts. If necessary, have the door seal replaced by a Qlima-approved
technician. Only use original Qlima spare parts.
6.7 CLEANING THE PELLET HOPPER AND AUGER
Clean the pellet hopper and auger once a month.
1.
4
2.
82
Only clean the glass window when the stove has completely cooled off!
The brazier and ash drawer must be cleaned before each start-up.
Remove the brazier and the ash drawer from the combustion chamber. See
figure 7.
Clean the ash drawer.
Clean the brazier and its grate with a brush or vacuum cleaner. If the slots in
the grate are blocked, use a pointed instrument to clear them (see figure 8).
Clean the space beneath the brazier and the space under the ash drawer
with a vacuum cleaner.
Open slots and a clean grille in the combustion chamber are of key
importance to the proper burning of the pellets.
Put the brazier and the ash drawer back into the stove. Make sure the bra-
zier is refitted correctly. Make sure the large opening is near the ignition rod
(as indicated in figure 9). If the brazier is refitted incorrectly, the stove will
not be lit.
Open the door and remove all ash with an ash vacuum cleaner.
Remove the brazier and the bottom of the combustion chamber (Pic. 7&10).
Extraction of the fire protection: push the fire protection upward to remove
it from the slot (Pic. 11).
Now use a brush and an ash vacuum cleaner, clean top and bottom of the
combustion chamber by removing all ash which has built up inside the com-
bustion chamber (Pic. 12-13).
Do the reverse process to re-assemble.
Remove the protective grille from the pellet hopper.
Empty the pellet hopper.