Installation Instructions - Klarstein ELBRUS Manual Del Usuario

EN
26
Unpack the unit
Note: This unit is heavy. Always seek help for unpacking or installation. Read
the entire instruction manual carefully before proceeding with unpacking or
installing the unit.
• Installation must be carried out by two adults to avoid injury or damage. If the
device is still too heavy, other people must be called in for support.
• When lifting, always make sure to keep your back as straight as possible and
bend your knees. Avoid twisting the hips. It is better to reposition your feet.
• Avoid lifting with the upper half of the body. Bend the knees and not the hips.
Do not lean forward or sideways while carrying the unit.
• Always hold the unit securely with the palms of your hands. Do not just use
your fingertips.
• Try to keep the unit as close to your body as possible. This shifts the centre of
gravity.
• Use work gloves for extra grip.
• Unpack the unit and carefully lift it out of the packaging. Place the unit on a
flat surface with the front panel facing forward.
Note: Before installation, make sure that the entire scope of delivery is
complete (see section "Package contents').

Installation instructions

CAUTION
Risk of electric shock! Do not connect the unit to the power supply
yet before installation, only plug it in when it is fully assembled and
securely fastened.
• The manufacturer cannot be held liable for any damage or injury resulting
from incorrect installation or improper handling.
• Remove any protective films on the outer surfaces, if present.
• Select a suitable installation site. Take into account the stability of the wall to
which the unit is to be attached. As part of user safety, make sure that the
load-bearing capacity of the wall and the holding capacity of the fixings are
sufficient. The unit should only be installed after all wet plastering and/or
drywall sanding and wall painting has been completed.
• The ventilation openings of the unit must not be blocked. The wall on which
the unit is installed must be level. Install the unit only on a vertical surface.
Avoid sloping surfaces. Installation on a wall other than a vertical wall may
cause fire, damage or injury.
• If the unit is to be mounted on the inside of a conventional cavity wall or a
solid wall, the dowels and fixing screws supplied can be used.
• Depending on the nature of the wall, it may be necessary to use additional
fixings.