Starting /Stopping The Blower; Operating The Blower - Snapper ESXDBL82 Manual De Utilización

EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
CHARGE BEFORE FIRST USE.
Always remove battery pack from the
product when you are assembling parts,
making adjustments, cleaning, or when not
in use. Removing battery pack will prevent
accidental starting that could cause serious
personal injury.
Do not allow familiarity with this product
to make you careless. Remember that a
careless fraction of a second is sufficient to
inflict serious injury.
Always wear eye protection with side
shields marked to comply with ANSI Z87.1,
along with hearing protection. Failure to
do so could result in objects being thrown
into your eyes and other possible serious
injuries.
Do not use any attachments or accesso-
ries not recommended by the manufacturer
of this product. The use of attachments
or accessories not recommended can
result in serious personal injury. Before
each use, inspect the entire product for
damaged, missing, or loose parts, such
as screws, nuts, bolts, caps,etc. Tighten
securely all fasteners and caps and do
not operate this product until all missing or
damaged parts are replaced.
English (original instructions)
WARNING
WARNING
WARNING
WARNING

STARTING /STOPPING THE BLOWER

See figure 6
Ensure that the battery is installed in the
„
blower.
„ To start the blower, press the On/Off
Button located on the blower. The LED
above the On/Off Button will be on.
„ Squeeze the trigger to start the blower.
„ Release the trigger and press the On/Off
button to stop.
To prevent serious personal injury or dam-
age to the unit, make sure the blower tube
is in place before operating the unit.
ADJUSTING THE AIR VELOCITY See
figure 7
This blower is equipped with a cruise control
function. Please read and understand the
function of the Cruise control lever.
„ Ensure that blower is on. The LED above
the On/Off Button will be on.
„ Squeeze the trigger to start the blower.
„ Once the blower is on, pull back the lever
clockwise to increase the speed. This will
lock the speed at the desired setting.
„ To decrease the speed, push the lever
counter clockwise to decrease the speed
to the desired setting.
NOTE: If you decrease the speed all the
way, the unit will shut off and step one will
need to be repeated.

OPERATING THE BLOWER

„ To keep from scattering debris, blow
around the outer edges of a debris pile.
Never blow directly into the center of a
pile.
„ To reduce sound levels, limit the number
of pieces of equipment used at any time.
„ Use rakes and brooms to loosen debris
before blowing. In dusty conditions,
slightly dampen surfaces when water is
available.
„ Conserve water by using power blowers
instead of hoses for many lawn and
garden applications, including areas such
6
WARNING