Special Maintenance; General; Cleaning The Cutting Bar And The Lubrication Holes; Chain Sharpening - CAMPAGNOLA KRONOS 58 Manual De Uso Y Mantenimiento

6.2

Special maintenance

6.2.1

General

The repair and special maintenance operations have to be carried out by a qualified mechanic.
Before any maintenance operation:
• Put on anti-puncture safety gloves.
• Put the ON/OFF switch (5) in OFF position.
• Disconnect the power supply cable (13).
All special maintenance operations (such as replacement of keyboard, power supply cable, motor, electronic
board, etc.) must be carried out at an Authorized Service Point.
AUTHORIZED SERVICE POINTS
These are the centres authorized by the Manufacturer to repair the products.
6.2.2

Cleaning the cutting bar and the lubrication holes

Clean these parts very often, especially every time before using the tool.
• Remove the chain (16) and clean its drive.
• Clean the lubrication holes.
6.2.3

Chain sharpening

Put-on anti-puncture safety gloves.
Follow the Manufacturer's instruction for the chain sharpening and maintenance operations. To decrease the
height of the depth adjusting device could mean to increase the kickback risk.
Each 3 or 4 chain sharpening operations check and, if necessary, file the depth adjusting device by means of a
flat file, then round its upper point.
The distance between the chain teeth is 1/4". Therefore, use a file with a 4 mm diameter as well as a flat one.
• Always sharpen the file starting from the inner part of the cutting side towards its outer part. Keep a 35° inclination.
• After sharpening, all the teeth must have the same size (length and width)
Keep the angle
File in the indicated direction
Put the depth calliper in stable position on the chain, so that the depth marker protrudes. File its protruding part till it
reaches the same level as the depth calliper. Round the front angle of the depth marker off.
Depth calliper
Use and maintenance manual – Translation of
original Instruction. : 01 date 15/12/2021
10° grip
File till it is as flat
as the calliper
When filing, keep a distance which is
1/5 of the diameter of the file
Round the
angle
Page 35