Adjusting Speaker Volume; Changing Channels; Channel Scan - Topcom TWINTALKER 1302 Manual De Usuario

13.2 ADJUSTING SPEAKER VOLUME

The Speaker Volume can be adjusted using
SC
LCD.
TX RX
13.3 RECEIVING A SIGNAL
The unit is continuously in the RECEIVE mode when the unit is ON and not transmitting. When you
receive a signal on the current channel, the RX icon is displayed.
SC
TX RX
13.4 TRANSMITTING A SIGNAL
• Press and hold
SC
• Hold the unit in a vertical position with the MICROPHONE 10 cm from the mouth and speak into the
microphone.
TX RX
• Release

13.5 CHANGING CHANNELS

The PMR has 8 available channels.
To change channels:
• Press
SC
• Press
• Press
PTT
TX RX
NOTE: Any PMR set on the same channel can receive and listen to the conversation.
13.6 MONITOR
You can use the MONITOR feature to check for weaker signals in the current channel.
• Press button for normal monitoring .
• Press and hold . After 5 seconds you can release the button. You are now continuous monitoring the channel
until you press again.

13.7 CHANNEL SCAN

CHANNEL SCAN performs searches for active signals in an endless loop from channel 1 to 8.
• Press and hold
• Release the buttons.The channel on the display changes as it scans through the channels.
SC
• When an active signal (one of 8 channels) is detected, CHANNEL SCAN pauses and you will hear the
active signal.
TX RX
• When an active signal (one of 8 channels) is detected, press
and continue to search for another active channel
• Press
PTT
scan.
TOPCOM TWINTALKER 1302
In order for other people to receive your transmission, they must be set
on the same channel.
to TRANSMIT.
PTT
when you have finished transmitting.
PTT
once, the current channel number flashes on the LCD Screen.
or to change the channel.
to confirm the channel selection and return to NORMAL mode.
and for 2 seconds.
to communicate through the active signal channel or press
TOPCOM TWINTALKER 1302
/ . The Speaker Volume level is displayed on the
or to bypass the current channel
to deactivate channel
7