Assembly - universalblue UCEF90101-20 Manual De Instrucciones

4. ASSEMBLY

Before assembling the product, remove all parts from packaging
and check that all parts are included. If any parts are missing or
damaged, please contact with the seller or manufacturer.
the following tools not included with the device will be required to
assembly the product:
• 10 and 13 mm open-end wrench
• 20 cm adjustable opening wrench
• 23 cm slip joint pliers
• Screwdriver with medium blade
• Soap mixture
Please check that your product include the following spare parts
required for assembly and included with the product:
• Gas cylinder base and 3 post brackets.
• 9 cap nuts (M6 mm), 9 small screws (M6 x 10 mm), 9 small
flat washers 6 mm
• 6 large bolts and flange nuts (M6)
• 3 medium bolts M8x15 mm
• 3 reflector spacer and wing nuts, 9 large flat washers
Please follow assembly instructions below. You
can find all the step-by-step images at the end
of this section.
STEP 1
1-1. Place the 3 post brackets in each position
on the base as shown in image 1
1-2. Use 3 medium screws (M8x15) to attach
the post brackets to the base.
29