General Information; Instructions For Use; Preparation For Installation - Varian Turbo-V 300 ICE Manual De Instrucciones

GENERAL INFORMATION

This equipment is intended for use by professionals.
The user should read this instruction manual and any
other additional information supplied by Varian before
operating the equipment. Varian will not be held
responsible for any events occurring due to non-
compliance, even partial, with these instructions,
improper use by untrained people, non-authorized
interference with the equipment or any action contrary
to that provided for by specific national standards. The
Turbo-V 300 ICE
microprocessor-controlled,
converters with self-diagnostic and self-protection
features.
The controllers drive
Turbo-V 300 ICE pump during the starting phase by
controlling the voltage and current respect to the speed
reached by the pump. They incorporate all the facilities
required for the automatic operation of the Turbo-V
300 ICE pump series.
Remote start/stop commands, pump status signals,
forepump start/stop commands, interlock control
signals (for pressure switch, water flow switch), heater
jacket control signals, flow meter control signals and
purge valve management signals are provided via
auxiliary connectors. The following paragraphs contain
all the information necessary to guarantee the safety of
the operator when using the equipment. Detailed
information is supplied in the appendix "Technical
Information".
This manual uses the following conventions:
!
The warning messages are for attracting the attention
of the operator to a particular procedure or practice
which, if not followed correctly, could lead to serious
injury.
The caution messages
procedures which, if not followed, could cause damage
to the equipment.
The notes contain important information taken from the
text.
87-900-902-01 (G) - TURBO-V 300 ICE CONTROLLER
series controllers
solid-state, frequency
(within ten steps)
WARNING!
CAUTION!
are displayed before
NOTE
STORAGE
When transporting and storing the controllers, the
following environmental
satisfied:
•
temperature: from -20 °C to + 70 °C
•
relative humidity: 0 - 95% (without condensation)

PREPARATION FOR INSTALLATION

The controller is supplied in a special protective
are
packing. If this shows signs of damage which may
have occurred during transport, contact your local
sales office. When unpacking the controller ensure that
it is not dropped or subjected to any form of impact.
the
Do not dispose of the packing materials in an
unauthorized manner. The material is 100% recyclable
and complies with EEC Directive 85/399.
Each controller is factory set for a specific power
supply:
•
model 969-9433 is factory set for 220 Vac
operation
•
model 969-9533 is factory set for 120 Vac
operation
Check voltage selector window for correct set and
connect power cord.

INSTRUCTIONS FOR USE

requirements
Controllers packing
should be
45