Troubleshooting - Hapro seecret C200 Instrucciones Originales

This symbol will appear on the display after 500 hours. It is preferable after 500 hours to replace the lamps with new. After
replacing the lamps reset the lamp hour counter.
Note: On the label on the back of the unit the lamps are stipulated that are suitable for your unit.
Resetting the hour counts
Hour counter lamps x 10
Reset hour counter lamps
Hour counter appliance x10
Cleaning
Always unplug the appliance and let it cool down before cleaning it.
● You can clean the outside of the appliance with a damp cloth. Make sure that no water runs into the appliance.
Never use scouring pads and abrasive liquids such as scouring agents, petrol or acetone to clean the appliance.
● Clean the protective goggles with a moist cloth.
Replacement
Lamp
The light emitted by the lamps will become less bright in time (i.e. after a few years in case of normal use). When this happens, you will notice
a decrease in the capacity of the appliance. You can solve this problem by setting a slightly longer session time or by having the lamps
replaced.
Always have the lamps and starters replaced by a service centre authorised by Hapro. Only they have the knowledge and skills required
for this job and the original spare parts for your appliance.
Protective goggles
Additional or replacement goggles can be ordered at your local dealer.
Environment
● The lamps contain substances that may pollute the environment. When you discard the lamps, do not throw them away with the
normal household waste, but dispose of them at an official collection point.
● Do not throw the appliance away with the normal household waste at the end of its life, but hand it in at an official collection point for
recycling. By doing this you will help to preserve the environment.
Guarantee & service
Our appliances are manufactured with the greatest attention and are of excellent quality.
Every Hapro Seecret® appliance is manufactured to meet the international IEC/EN standards. We provide a manufacturer's warranty of 1 year.
Your new appliance has a manufacturer's guarantee of 1 year, which commences on the date of installation. Within the warranty period all
faults that are the result of material or manufacturing errors will be repaired at no cost. Please contact your dealer for any warranty enquiries.
In order to make a claim under the terms of this guarantee, you must be able to produce the original invoice or receipt bearing the date of
purchase. The type and serial number of the appliance should also be indicated.
The warranty is subordinate to the national regulations on pro duct warranties.
Not covered under this warranty
Appliances which have the type, serial number and/or other identification labels removed, damaged or altered.
Lamps, starters and acrylic sheets.
Damage due to purchaser abuse, neglect, transport, improper use or improper maintenance.
Damage due to use of accessories not originally supplied by Hapro or inferior accessories.
Damage due to installation, repair or assembly not done by Hapro authorised personnel.
Damage due to fire, lightning, earthquakes or other natural disasters.

Troubleshooting

If problems should arise with this appliance and you are unable to solve them by means of the information below, please contact the nearest
Hapro dealer.
When your appliance does not operate as expected this may be due to a disturbance and/or defect. Before reporting this problem to your
dealer you should check whether the unit has been properly installed. The following situations apply:
a. Mechanical defect. Check whether your appliance has been properly installed by once more reading the assembly instructions.
b. Electrical defect. Try to correct the defect using the trouble-shooting guide below.
Note: Do not use your appliance when the ventilation is defective or is not functioning optimally or the timer is defective.
Problem
The appliance does not start.
The fuse blows in use
Solution
a. Check that the plug is properly connected to the all socket power supply
b. There may be a power failure. Check if the power supply works by connecting another appliance.
Check the rating of the fuse. This should be: 16A slow
- 4 -