keys can be used to adjust the partial light output setting for the slave flash
units of group C, from 1/1 to 1/128.
• To deactivate slave group C, press the "Mode" key repeatedly until only C
appears on the LC display.
Setting the remote channel
• Press the "Para" key repeatedly until "Ch" flashes on the LC display.
• Set the remote channel using the (+) and (-) keys.
Setting the zoom position of the reflector
• Press the "Para" key repeatedly until "Zoom" appears on the LC display.
• Set the zoom position using the (+) and (-) keys.
Setting the master flash unit
• Press the "Para" key repeatedly until M or M TTL (for master flash unit) appe-
ars on the LC display.
• To activate the master flash unit, press the "Mode" key until M M appears on
the LC display. While M is displayed, the (-) and (+) keys can be used to adjust
the partial light output setting for the master flash units, from 1/1 to 1/256.
• To deactivate the master flash unit, press the "Mode" key until only M appears
on the LC display
19.3 Settings on the slave flash unit
• Use the „Para" key to select, in succession, the settings for choice of slave
group („Group"), the remote channel („Channel") and the reflector position
(„Zoom"). Use the (-) and (+) keys to set the desired slave group or remote
channel and the zoom position of the reflector.
The slave flash unit must be adjusted to the same remote channel as the
master flash unit! The slave operating mode (E-TTL remote or manual
remote) cannot be set on the slave flash unit, because this is controlled
automatically by the master flash unit!
• Press „Return"
to save your settings. If the „Return" key
the settings will be saved automatically after approximately 5 seconds.
19.4 Testing remote operation
• Place the slave flash units in the desired positions for the shot.
• Wait for all of the flash units involved to become flash ready. The AF measu-
ring beam will also blink on the slave flash units when they are flash ready.
Activate audio signals (beep) if desired (see 7.2).
• Press the manual firing button
The slave flash units will respond in succession, according to slave group, with a
test flash. If a slave flash unit fails to fire a test flash, check the settings for remote
channel and slave group. Correct the position of the slave flash unit so that it is
able to receive the light from the master flash unit.
20. Low battery warning indicator
When the battery symbol on the LC display flashes, please insert new batteries.
21. Care and maintenance
Remove dust and grime with a soft dry cloth or silicon-treated cloth. Do not use
cleaning agents as these may damage the plastic parts.
22.1 Firmware updates
The flash unit's firmware can be updated through the USB port
to the technical requirements of future cameras (Firmware Update).
For more information, visit the Metz homepage at www.metz.de.
21.2 Reset
The flash unit can be reset to the factory settings. To do this, press the „Mode"
key and hold it down for approx. 3 seconds. „Reset" will then appear on the
display panel. After about 3 seconds the display reading will return to the facto-
ry setting.
is not pressed,
This will not affect the firmware updates for the flash unit.
on the master flash unit to fire a test flash.
and adjusted
115