How To Control Your Model - Hobbytech NXT SPIRIT EP 2.0 Manual De Instrucciones

BIND
A
Pairing your receiver to your KT3S+
Place model on a block to prevent wheels from touching the
ground.
A
Connect battery to ESC. Fix the wire correctly with the
provided connectors.
You must check the signal of transmitter and receiver before
you operating it at first.
Make sure TH Trim is on neutral
- TURN OFF THE TRANSMITTER AND RECEIVER -
1. Transmitter turned off, power the receiver On
The receiver LED flashes Red.
2. Press and Hold the «BIND/EPA» transmitter button while
powering On the transmitter
The receiver LED becomes solid Red, and the transmitter solid
green: your receiver is paired with your transmitter. You can
release the «BIND/EPA» button.

HOW TO CONTROL YOUR MODEL

1. Pull up the trigger in order to brake or speed down
2. Pull the trigger in order to go forward or speed up
B
(via ESC).
C
.
FORWARD / SPEED
UP POSITION
LEFT
If the wheels operate in the opposite direction,
operate the servo reverse switch (ST in position NOR).
B
(2)
C
NEUTRAL
RIGHT
(1)
BRAKE / SPEED
DOWN POSITION
NEUTRAL POSITION
7