Parts And Components; Before Use; Installation; Operation - cecotec CONGA COLLECT 10000 Manual De Instrucciones

ENGLISH

1. PARTS AND COMPONENTS

Conga Home
Fig. 1.
1. LED indicator.
2. Accessories container.
3. Container cover.
4. Ventilation grille.
5. Charging contacts.
6. Dirt removal port.
Fig. 2.
7. Power cord.
8. Cable channeling slot.
Fig. 3.
9. Cleaning brush.
10. Bag compartment.
11. Mop storage compartment.
12. Filter cleaning compartment.

2. BEFORE USE

- Take the product out of the box and remove all packaging materials.
- Make sure all parts and components are included and in good conditions. If any sign
of visible damage is observed, contact immediately with the official Technical Support
Service of Cecotec.

3. INSTALLATION

Conga Home Installation. Fig. 4.
Connect the Conga Home to a power outlet and save the remaining cable. It is important to
channel the cable to avoid disconnecting or dragging it.
Place the charging base against the wall, leaving the safety distance indicated in the picture
below.
Note: Ensure a space of at least 0.5 m on both the left and right side of the charging base, and
a space of at least 1.5 m in front of it.
26 CONGA HOME 10000
Warning
Do not expose the charging base to direct sunlight.
Recommendation
Remove the mop bracket when the robot is charging or not in use.

4. OPERATION

- Conga Home does not allow to empty the dirt tank without removing it from the robot.
- Once it is clean and the robot is in the vacuuming base, it will start the autoclean function.
We will know it is operating because of the following indicator lights:
- The indicator light will turn oscillating green when the robot is charging.
- The indicator light will turn steady green when the robot is charging or out of the base.
- The indicator light will turn oscillating orange when the vacuuming mode is on, or when
we place the high-efficiency filter in the cleaning space.
- The indicator light will turn steady red when the vacuuming system stops working.
- The indicator light will turn oscillating red when the vacuuming system stops working.
Functions
- Robot vacuum charging base.
- Autoclean system.
- High-efficiency filter cleaning system.
- Spare parts and cleaning tools container.

5. CLEANING AND MAINTENANCE

Bag replacing.
- Lift the container cover to open it. Fig. 5
- Pull the bag upwards grabbing the cardboard card and dispose of the bag. Fig.6
-
Place the new bag by sliding the cardboard card on the guides. Press the cover down and
make sure it is closed. Fig.7
Bag emptying
To empty the bag we will follow the same steps below, but we will place the same one during
its lifespan.
Extractor cleaning. Fig. 8
Perform a visual inspection of the extractor and remove any lint or dirt that may have
escaped from the bag.
ENGLISH
CONGA HOME 10000 27