• When not in use, the product must
be kept out of the reach of the
child.
• To avoid STRANGULATION, when
in use, roll and fasten the free ends
of the lower fastening straps, using
the elastic holes provided.
• When in use, always check that
the crotch strap is at a height of
at least 250 mm from the base
of the seat.
COMPONENTS
A. Fabric structure
A1. Crotch Strap
A2. Rear fastening straps
A3. Lower fastening straps
A4. Elastic holes for lower fastening straps
A5. Pockets for lower fastening straps
A6. Rear strap fastening band
A7. Snap button
A8. Carry-all bag
FIRST ASSEMBLY AND INSTALLATION
1. Open the snap button A7 (Fig. 1) and unroll the product until it
is completely open.
2. Extract the lower fastening straps A3 from the pockets A5 (Fig. 2).
3. Position the product on the seat (Fig. 3). To use this product, the seat
should have at least the minimum dimensions illustrated in Fig. 4.
4. Fasten the lower fastening straps A3, wrapping them around the
seat of the adult chair (Fig. 5). Pull on the free ends of the straps to
adjust the length so that they are nice and tight and the product
is securely attached to the chair (Fig. 6). Fasten the free part of the
straps with the elastic holes A4 (Fig. 7).
5. Position the rear strap fastening band A6 on the backrest of the
adult chair, letting it fall along the back of the adult chair (Fig. 8).
Fasten the rear fastening straps A2 behind the backrest of the
adult chair passing them through one of the holes of the band
A6, so that the straps A2 run straight across the backrest of the
chair (Fig. 9).
6. Place the child in the product (Fig. 10) and pull on the rear fasten-
ing straps A2 until they are at maximum tension (Fig. 11).
7. The product is equipped with a practical carry-all bag, located at
the top. Simply pull on the zipper to open the bag (Fig. 12).
CLOSURE
The product can be closed by rolling it up.
1. Release the seat's lower and rear fastening straps.
2. Position the lower fastening straps A3 in the pockets A5 and the
straps A2 inside the product (Fig. 13).
3. Roll the product on itself starting from the bottom (Fig. 14) and
wrap the band A6 around it (Fig. 15). Fasten the button A7.
CLEANING AND MAINTENANCE
Cleaning and maintenance operations must only be carried out by
an adult. Periodically check the product for any broken, damaged or
missing parts: if present don't use the product.
Please refer to the care label.
After cleaning, check the sturdiness of the fabric and the seams
every time.
Hand wash
Do not bleach
30° C
Do not tumble dry
Do not iron
Do not dry clean
WARRANTY
The product is guaranteed against any lack of conformity under nor-
mal use as specified in the instructions.
The warranty does not, therefore, apply to damage caused by
improper use, wear or accidents. For the duration of the warranty
against lack of conformity, see the specific provisions of applicable
national laws in the country of purchase, where present.
8