Safety Instructions; Startup - AL-KO JET 1300 INOX Traducción Del Manual De Instrucciones Original

en
cally after a cooling down period of approx. 15 -
20 minutes.

SAFETY INSTRUCTIONS

CAUTION!
The domestic water system may only be
connected to an electrical device which
is compliant with DIN/VDE 0100, Parts
737, 738 and 702 (swimming pools).
Make sure that fuse protection in the
form of a 10 A automatic cut-out and a
fault current guard circuit with a nominal
fault current of 10/30 mA is installed.
CAUTION!
The supply voltage and current specified
on the type plate must be identical with
the voltage and current of your electrical
system.
CAUTION!
If you need to connect your domestic wa-
ter system to an extension cord, make
sure that the cable is 3 x 1.5 mm2, which
it corresponds to type H07RN-F and is
compliant with DIN 57282/57245. The
connector must be splash-proof. Cable
drums must be completely unwound.
CAUTION!
Do not attempt to make any changes or
modifications to the device by yourself.
You may endanger your life or invalidate
the warranty.
CAUTION!
Do not operate the system if it is dama-
ged. Necessary repairs must be carried
out in a qualified AL-KO service centre.
CAUTION!
Never use the electric cable to lift, carry
or attach the system to another object.
Do not pull on the cable when unplugging
the system.
12
CAUTION!
Make sure that the system is unplugged
before beginning any maintenance, re-
pair or cleaning work. In the event of a
malfunction, immediately unplug the sys-
tem. Make sure that the plug does not
get wet.
CAUTION!
The domestic water system may not be
used for any other than its designated
use. Before putting the system into ope-
ration, make sure that
the pump, reservoir, the electric ca-
ble and the plug are not worn or da-
maged.
CAUTION!
Risk of injury due to hot water!
The water in the pump can heat up signi-
ficantly, during longer periods of opera-
tion (>10 min) against closed outlet side.
This hazard can occur due to:
side under compression closed
water shortage in the suction line
improper installation
In this case:
isolate the pump from the mains
allow the pump and water to cool
down
check water level on inlet side
check lines for tightness
check installation
only restart pump after rectifying the
cause of the fault
Children, or other people who are not familiar
with the operating instructions, are not allo-
wed to use the machine

STARTUP

Place the garden pump onto a hard, flat sur-
face so that it cannot tip over and so that it
will not be near the flow of water.
Make sure that the pump is protected from
rain and any direct exposure to water.
Safety instructions
JET 1300 (INOX)