Intended Use - Worx Professional WU404 Manual Del Usuario

Operating instructions
Note: Before using the tool, read the instruction book carefully.

INTeNded USe

The machine is intended for cutting, roughing, and brushing metal
and stone materials without using water.
For cutting metal, a special protection guard for cutting (accessory)
must be used.
For cutting stone, a special extraction hood for cutting with cutting
guide (accessory) must be used.
With approved sanding tools, the machine can be used for sanding
with sanding discs.
KNOW YOUR ReCIPROCATING SAW
vibrafree ™ ReCIPROCATING SAW are uniquely designed to
cancel out the saw's vibration in every load condition. This active
vibration canceling technology makes this saw more comfortable
and easy to use, taking the vibration out of the saw, the workpiece,
your hands and arms, and putting this energy to work sawing and
removing material.
1
TRIGGeR SWITCH (See Fig. A)
Depress the switch to start and release it to stop your tool.
The blade plunger stroke rate can be adjusted from the minimum
to maximum by the pressure you apply to the trigger. Apply more
pressure to increase the speed and release pressure to decrease
speed. (See Fig. A)
All manuals and user guides at all-guides.com
2
8
VARIABLe SPeed dIAL (See Fig. B) (only for WU407)
The strokes per minute can be adjusted just by turning the variable
speed dial. This can be done even while the tool is running. The
control is marked 1 (lowest speed) to 6 (full speed). Turn the speed
control without positive stops between 1 and 6 according to your
work. Refer to the table to select the proper speed for the workpiece
to be cut. However, the appropriate speed may differ with the type
or thickness of the workpiece. In general, higher speeds will allow
you to cut workpieces faster but the service life of the blade will be
reduced.
Speed setting
6
5
4
3
2
1
Material
Wood
Autoclaved lightweight concrete
Mild steel
aluminum
Plastics
Stainless steel
Note:
• If the tool is operated continuously at low speeds for a long period
of time, the operation life of the motor will be reduced.
• The variable speed control can be turned only as far as 6 and back
to 1. Do not force it past 6 or 1, or the speed adjusting function may
no longer work.
Strokes per minute
3,000
2,300
1,900
1,700
1,500
1,200
Speed setting
6
5-6
3-4
3-5
1-4
1-2