Line Cut-Off Blade; General Maintenance - Snapper ESXDST82 Manual Del Usuario

EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK

LINE cUT-oFF bLADE

This trimmer is equipped with a line cut-off
blade on the grass deflector. For best cutting,
advance line until it is trimmed to length by the
line cut-off blade. Advance line whenever you
hear the engine running faster than normal,
or when trimming efficiency diminishes. This
will maintain best performance and keep line
long enough to advance properly.
When servicing, use only identical replacement
parts. Use of any other parts may create a
hazard or cause product damage.
To avoid serious personal injury, always
remove the battery pack from the tool when
cleaning or performing any maintenance.

GENERAL MAINTENANcE

Before each use, inspect the entire product
for damaged, missing, or loose parts such
as screws, nuts, bolts, caps, etc. Tighten
securely all fasteners and caps and do
not operate this product until all missing or
damaged parts are replaced.
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to damage
from various types of commercial solvents
and may be damaged by their use. Use clean
cloths to remove dirt, dust, oil, grease, etc.
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils,
etc., come in contact with plastic parts.
Chemicals can damage, weaken or destroy
plastic which may result in serious personal
injury.
Only the parts shown on the parts list are
intended to be repaired or replaced by the
English (original instructions)
wARNING
wARNING
wARNING
customer. All other parts should be replaced
at an Authorised Service Centre.
SPooL REPLAcEMENT See Figure 10.
Use original manufacturer's replacement
cutting line for best performance.
„ Remove the battery pack.
„ Push in tabs (a) on sides of spool cover
(b).
„ Pull spool cover up to remove.
„ Remove the old spool (c).
„ To install the new spool, make sure the
cutting line is captured in the slot on the
new spool. Make sure the end of the
cutting line is extended approximately
15cm beyond the slot.
„ Install the new spool so that the cutting
line and slot align with the eyelet in the
cutting head. Thread the cutting line into
the eyelet.
„ Pull the cutting line extending from the
cutting head so the cutting line releases
from the slot in the spool.
„ Reinstall the spool cover by depressing
tabs into slots and pushing down until
spool cover clicks into place.
cUTTING LINE REPLAcEMENT
See Figures 11-12.
„ Line up the slots on (a) the spool cap (b)
with the slots on the string head (c).
„ Insert line through the string head hole (d).
Push line until it exits the opposite string
head hole.
„ Pull the line through until there is an equal
amount of line on each side.
„ Turn the spool cap clock-wise to begin
winding the string into the string head.
Leave approximately 5 inches of string
protruding out of each side of the head.
7