Abicor Binzel MIG Robo Manual Del Usuario página 38

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

11 Dismounting
Fault
Erratic arc
Pore formation
Tab. 11
Troubleshooting
11 Dismounting
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance,
servicing, mounting, dismounting and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Switch off the entire welding system.
NOTICE
• Dismounting may only be carried out by qualified personnel
(in Germany see TRBS 1203).
• Please consult the operating instructions for the welding components, such as the power
source, wire feeder, recirculating cooling unit, etc.
• Observe the information provided in the following section:
 8 Putting out of operation on page EN-12.
1 Disconnect the cable assembly from the wire feeder.
2 Remove the parts to be disconnected (changeable body, bracket, CAT robot mount, torch
neck).
EN - 18
All manuals and user guides at all-guides.com
Cause
• Contact tip not matched to the wire
diameter or contact tip diameter
enlarged
• Wrong welding parameters set
• Wire guide unit worn out
• Strong spattering in the gas nozzle
• Insufficient or lack of gas coverage
• Air currents blowing shielding gas
away
MIG/MAG ROBO welding torch
Troubleshooting
• Check the contact tip
• Correct the welding parameters
• Replace the wire guide liner unit
• Clean the gas nozzle
• Check the gas cylinder contents
and pressure setting
• Shield the welding area with
partitions

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mag robo

Tabla de contenido