For Your Safety - Würth ALG 18/4 BASIC Manual Del Usuario

GB ANZ
WARNING
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may result in electric
Save all warnings and instructions for future reference.
Please read and observe these instructions before using the
product. Failure to follow these instructions and warnings
Do not recharge primary
WARNING
cells (non-rechargeable).
This appliance is not intended
WARNING
to be used or cleaned by persons with
reduced physical, sensory or mental
capabilities, or lack of experience or
knowledge, unless they have been given
instructions concerning the safe use
of the appliance by a person legally
responsible for their safety. They should
be supervised whilst using the appliance.
Children shall not use, clean or play with
this appliance, which when not in use
should be secured out of their reach.
If the supply cord is damaged,
WARNING
it must be replaced by the manufacturer,
persons in order to avoid a hazard.
WARNING
Mains voltage must correspond with the voltage
WARNING
product damage due to a short circuit, never immerse your tool,

For Your Safety

when the operating and safety information are read
completely and the instructions contained therein
are strictly followed.
Before using the product, check that the product enclosure, cable
and adaptor plug are not damaged. If damage is found, do
not use and follow instruction in the maintenance section of this
manual.
The product must not be damp, and should never be used in a
damp environment.
The product is for indoor use only.
or is damaged in any other way.
Do not conduct charging in a position which may become
exposed to sunlight or other heat source.
Due to the heat generated during charging, the product should
not be operated on a combustible surface.
materials. Example: Cloth, packaging materials, paint, spray paint
or aerosols, lubricant, thinners, petrol containers, gas containers
or gas appliances.
Do not cover any ventilating slots and provide adequate
ventilation during operation.
Never modify, disassemble or attempt to repair the product
yourself.
Do not allow the charger or batteries to become contaminated
with any material which could be conductive. Example: Metal
particles from grinding, cutting or machining processes.
Remove the plug of the product from the power socket when it is
not in use or when cleaning it.
Only use extension cable that is approved and in good condition.
Protect battery contacts to avoid a short circuit caused by metallic
Do not charge batteries which show signs they have leaked
electrolyte. Dispose of them properly.
Never charge a damaged battery pack. If damaged, replace
immediately.
If the battery is not going to be used for a while, remove the
product.
chemicals, and bleach or bleach-containing products, etc., can cause
a short circuit.
9