Use; Initial Use; Maintenance And Cleaning; Maintaining And Cleaning The Fitting - LIVARNO home WU6823481-8 Instrucciones De Montaje

Detach the fastening nut
Screw the short side of the tap thread
the tap body .
24
By hand, screw both of the flexible connecting
hoses from below into both of the correspon-
8
ding hose mounts in the tap body
circumstances should you use tools to screw the
connecting hoses
that the connecting hoses
and are not being clamped.
Place the base ring seal
the base ring
.
16
Ensure that the base ring seal
correctly in the corresponding groove.
Place the tap body
that the base ring
16
hole for the tap.
Guide the plastic triangle
ing ring , the transparent washer
12
the fastening nut
10
necting hoses from below. When using the
8
plastic triangle, ensure that the flat side is fac-
ing upwards so that it lies directly on the under-
side of the sink unit when installed.
Fix the tap to the sink unit by hand-screwing the
fastening nut into the tap base from below
10
until it stops.
Screw the connecting hoses onto the corner
valve on your wall connection.
Make sure that you attach both connecting hoses
correctly to the hot or cold water connections.
After successfully installing the product, turn on
the hot and cold water supplies.

Use

Initial use

Carefully check all connections for leaks after first
use to ensure that they are sealed sufficiently.
Check that the tap is operational. To do so,
swing the tap lever
positions.
16 GB/IE
from the tap thread
10
into
14
. Under no
24
into the tap. Make sure
8
are running straight
8
into the groove on
15
is positioned
15
onto the sink unit so
24
encircles the mounting
, the silicone seal-
13
and
11
if necessary over the con-
into all permissible
3
Note: the tap is equipped with an LED light. The LED
.
14
is lit through an integrated turbine (without batteries).
The LED colour changes automatically based on the
water temperature, thanks to an integrated tempe-
rature sensor:
· up to approx. 32 °C: blue
· from approx. 33–40 °C: green
· from approx. 41–45 °C: red
· above approx. 45 °C: flashing red
Open the main water supply.
Lift the tap lever
left to regulate the flow or temperature of the
water.
Hot water:
swing the tap lever
Cold water:
swing the tap lever

Maintenance and cleaning

Maintaining and
cleaning the fitting
Please note that sanitary taps require special care and
attention. Therefore, please follow the instructions:
Never clean with petrol, solvents or aggressive
cleaners or hard bristled brushes, etc. These
could damage the product surface.
Dry your tap with a cloth after every use to
prevent any lime deposits.
Clean the product with a damp, soft cloth and,
if necessary, mild detergent.
Failure to observe the above care advice can be
expected to result in damage to the surfaces of the
product. This will inevitably invalidate the warranty.

Replacing the LED insert

If the LED bulbs fail to light up, the LED insert
be replaced.
LED service life: approx. 10,000 operating hours.
and swing it to the right or
3
to the left.
3
to the right.
3
can
20