Dell PowerVault 725N Manual Del Usuario página 31

JO525bk0.book Page 25 Monday, January 27, 2003 12:29 PM
F i g u r e 1 - 1 7 .
I n s t a l l a t i o n
nuts (2 per bracket)
shoulder washers
(2 per bracket)
mounting flange
Install the stiffening bracket in the appropriate holes at the back of the slide
12
assemblies and secure the bracket with a 12-24 x 0.5-inch pan-head Phillips screw on
each slide assembly (see Figure 1-16).
If the vertical rack is 3 inches wide, use the holes at the back end of the slide
assemblies (shown in Figure 1-16). If the vertical rack is 6 inches wide, use the holes
located 3 inches in front of the holes at the back end of the slide assemblies.
Grasp the cable tray at each end and lower it into the holes on each slide assembly (see
13
Figure 1-16).
Press the front hook firmly into its socket until it clicks, securing it in place.
14
All manuals and user guides at all-guides.com
R o t a t i n g t h e F r o n t M o u n t i n g B r a c k e t f o r F l u s h - M o u n t
12-24 x 0.5 inch pan-head Phillips screws
(remove 2 per bracket)
NOTE: These screws are shown reinstalled on
the other slide assembly.
Rack Installation Guide
1-25