Finishing The Installation; Operating Your Fan; Attaching The Fan Blades - Fanimation AIRE DECOR BP200 1 Serie Manual Del Usuario

7. FINISHING THE
INSTALLATION
STANDARD CEILING INSTALLATION
Slide canopy up to the ceiling as shown in Figure 16.
Make sure you place the wires safely into the outlet
box. Secure the canopy to the hanger bracket with
the four screws with your fan.
CLOSE-TO-CEILING INSTALLATION
Remove the fan from the hook on the hanger bracket.
Secure the canopy to the hanger bracket as shown in
Figure 17 with four screws included with your fan.
8. ATTACHING THE FAN
BLADES
Remove and discard the five rubber/screws motor
stops from the motor assembly. (Fig. 18)
Outlet box
Hanger
bracket
Ceiling
canopy
Figure 16
Outlet box
Hanger
bracket
Ceiling
canopy
Figure 17
Figure 18
9
Step 1 Attach the blade to the blade holder using
the screws and fiber washers (BP200** only) as
Screws
shown in Figure 19. Start screw into balde holder.
Repeat for the two remaining screws.
Step 2 Tighten each screw. Make sure the blade is
straight.
Step 3 Fasten blade assembly to motor using the
screws supplied. (Fig. 19)

9. OPERATING YOUR FAN

Turn on the power and check the operation of your fan.
Screws
The pull chain controls the fan speed as follows:
1. 3-speed pull chain: controls fan speed in the following
sequence: Off - High - Medium - Low - Off.
Ceiling fan performance and energy savings rely
heavily on the proper installation and use of the
ceiling fan. Speed settings for warm or cool weather
depend on a variety of factors such as room size,
ceiling height and number of fans. For best energy
efficiency, fan should be mounted in the middle of the
room and at least 7 feet above the floor and 18 inches
from the walls. If ceiling height allows, install the fan
8 - 9 feet above the floor for optimal airflow.
2. The slide switch controls directions: forward
(switch down) or reverse (switch up).
NOTE: Wait for fan to stop before changing the setting
of the slide switch.
Warm weather - (Forward) A downward airflow creates
a cooling effect as shown in Fig. 20. This allows you to
set your air conditioner on a warmer setting without
affecting your comfort.
Cool weather - (Reverse) An upward airflow moves
warm air off the ceiling area as shown in Fig. 21. This
allows you to set your heating unit on a cooler setting
without affecting your comfort.
Screws
Fiber washers
(BP200** only)
Screws
Blade
Blade holder
Figure 19
Figure 20
Figure 21
ENERGY SAVING TIP:
Turn off fan when not in room
Ceiling fans cool people, not rooms. If the room
is unoccupied, turn off the ceiling fan to save
energy.
10