Assembly & Use - NUTRIBULLET Juicer Pro Manual De Instrucciones

Assembly & use
1
Place the Motor Base on
a dry, level counter top.
Ensure the dial is set to the
"OFF"
position and the unit is
unplugged.
3
Sieve
Align the with the motor
drive coupling and push
down until it clicks into place.
Sieve
Handle the by gripping
the top edges being careful
not touch the sharp teeth on
the base of the Sieve. Ensure
the Sieve is properly seated
in place and securely inside of
the Pulp Basin.
10
2
Place the Pulp Basin on top of
the Motor Base. Align the Pulp
Basin
with the Motor Base so
that the spout is aligned with
the dimpled side of the Motor
Base.
4
Basin Cover
Place the over
the Sieve and Pulp Basin.
The side "ears" on the Basin
Cover
should align with the
"ears" on the sides of the Pulp
Basin.
5
Locking Handle
Raise the
and move it into the "ears" on
each side of the Basin Cover.
Locking Handle
The should
be in a vertical position and
locked into place.
NOTE: Locking Handle
if the is not
securely in place, the juicer will not
power on.
7
Juice Pitcher Lid
Place the on
top of the Juice Pitcher, and
open the locking lid latch.
6
No-Drip Spout
Swing the
cover up vertically so that it is
no longer covering the juice
spout.
8
Juice
Slightly angle the
Pitcher and place it under the
juice spout. Align the spout
Juice
with the hole in the
Pitcher Lid
and level out the
Juice Pitcher. It will fi t snuggly
into the spout to hold it in
place.
11