NUK 10.256.317 Manual De Usuario página 31

Problem Possible cause
Device does Mode selector switch in
not start OFF or incorrect position
when ON
button
Fuse in vehicle adapter
pressed
defective
Excessive temperature
cut-out has responded
(device is switched off if a
certain maximum
permitted temperature is
exceeded)
The automatic cut-out
(thermostat) is still active
Food not Device is switched off
getting hot
No water in the warming
tank
Incorrect accessories for
the selected bottle/jar
Food getting Too much water in the
too hot warming tank
zur Verfügung gestellt von Gebrauchs.info
Solution
"Home" mode: set the mode selector switch to
"Home".
"Car" mode: set the mode selector switch to "Car".
Check whether the fuse is defective. In this case,
replace the defective fuse (to replace the fuse, see
Section 3.3).
Device can no longer be used. Use one of the NUK
contact addresses.
Wait until the device has cooled down and can be
switched on.
Switch on the device by briefly pressing the ON
button down until the indicator lamp comes on
(Section 2.2).
If the indicator lamp does not come on, see
troubleshooting for the device not starting.
Pour water into the warming tank using the
measuring beaker. See Table 1 on Page 19 for the
required quantity of water.
See Table 1 on Page 19 for the correct
accessories to use for your bottle/jar.
See Table 1 on Page 19 for the quantity of water
required. Use the measuring beaker to pour water
into the warming tank and note the exact quantity
specified.
- 31 -
Aktualisierungsstand Gebrauchs.info November 2013