Publicidad
Step 4: Attach the handlebar
Insert the ends of the handlebar into the handlebar rods, line up the holes, insert
the safety pins and lock them.
Adjust the handlebar to the desired height by pushing the two red buttons.
Step 5: Attach the front wheel to the frame
Insert the buggy wheel into the mount bracket and use the safety pin to lock it
into place as shown. Make sure that it is firmly locked.
Step 6: The tow bar should be connected to the
bicycle using the connector provided. Attach the
connector to the left hand side of the rear wheel
of the bicycle by removing the axle nut. 7Place the
connector onto the axle and re-tighten the axle nut.
If your bicycle has a quick-release wheel, remove
the quick-release pin from the axle, insert it into the
tow bar and re-attach it through the axle again.
The coupler should be installed with the male
connector piece facing backwards and angled
away from the bicycle. Place the trailer behind the
bicycle so that the female connector can slide onto
the male connector.
Secure the connectors firmly using the split pin
provided. Loop the black safety leash around the
bicycle frame and attach the clip to the D-ring on
the two rods.
Adjust the
handle to the
desired height by
pressing the two
red buttons.
Publicidad
