Olympia NC 520 Plus Manual De Instrucciones página 19

Æ Pivot the grip to the rear.
Æ Pivot the operating panel to the front.
Clean areas which cannot be accessed using com­
pressed air, if necessary. Compressed air can be
obtained in small aerosol cans.
Æ Clean the sensors with the brush supplied.
Æ Close the machine in the reserve sequence after
cleaning.
Adjusting the Pressure of the Infeed Plate
The bank note counter is set-up at the factory to draw
the bank notes in properly. If bank notes are no longer
drawn in properly, adjust the pressure exerted by the
infeed plate.
The adjusting screw to alter the pressure exerted by the
infeed plate is located at the rear.
28 Adjusting screw
29 Locking screw
The adjusting screw is secured against being adjusted
inadvertently by means of a locking screw.
Æ Switch the bank note counter off.
Æ Loosen the locking screw using the screwdriver sup­
plied.
Æ Adjust the pressure of the infeed plate so that the bank
notes can be pushed under the rubber rollers by exerting
a little force.
Æ Tighten the locking screw.
G
28
29
19