ZUMEX Essential Manual De Usuario página 18

6 Remove the blade holder (Fig. 7) by pulling it towards you using the handle.
WARNING!
!
handle this piece very carefully as you could cut yourself.
7
Pull the ejectors out until it is completely free from the machine (Fig. 8). To
assemble them again, place the ejectors on the corresponding side and insert
them onto the knobs. Push the ejector until the blade is fully inserted into the
lower pressing unit and the channel makes contact with the second knob.
Important: Remove the ejectors before removing the pressing units of the
juicer. If the ejector is not correctly installed as indicated above, the part
may be damaged when the machine is in operation.
8 Remove the pressing units in pairs, after having unscrewed the knobs that
hold them in place (Fig. 9).
Versatile Pro
1 Dismount the container unit and PulpOut in one step. To do so, press the
front buttons on the PulpOut (Fig. 17) until both parts of the cover are
released, sliding it all outwards.
To assemble it again, hold the container with both hands and position it on
the guide rails of the cover and push it until it is fully inserted. Then press
both upper sides of the PulpOut until both buttons move outwards and sit
in line with the protruding lines on the front (Fig. 18)
! Important: If the container is not correctly assembled, the machine and the
PulpOut cannot be activated.
2 Remove the PulpOut from the container. (Fig. 17.3)
3 Place the PulpOut system on a smooth surface, place your fingers on the
inside of the right roller of the sweeping belt and push it outwards to
release it. (Fig. 19) Pull out the sweeping belt together with the other roller
and remove both parts. To assemble it again, put the rollers into the belt,
insert the left roller at the side of the PulpOut and then stretch the belt to
insert the right roller.
4
Disassemble the filter by pulling the tab.
5
Empty contents of the container and place it upside down on a flat surface.
6 Press the plastic pins of the tap and remove the pivots inserted in the
container (Fig. 11). Remove the back part first and then remove the front part.
To assemble, follow these steps in reverse order: first, insert the front part
into the container, then press the pins until the pivots fit into the holes of the
container. Lightly pull the faucet to check that it has been correctly inserted.
Remove the front cover by opening the side catch (Fig. 14). Turn the cover
7
90º to the right until it is outside the feeder. Pull upwards until it is released
from the hinges. To assemble it again, hold the cover firmly with both hands
and mount it in its fully open position, taking care to insert the three hinges
into their holes. Close the cover and lock its position.
Important: Always disassemble the container before removing the cover.
!
Do not remove the cover until it is in its fully open position. Avoid carrying
weight on the cover as this could strain the hinges. Ensure that the cover is
correctly inserted in its three hinges before closing it.
8 Remove the 1Step Kit (Fig. 15-16) from the machine. First, check the
assembly and disassembly instructions in the following section 1Step
Extraction Kit.
There are two possibilities when cleaning:
• Complete cleaning: once the unit has been removed from the machine,
get rid of extra pulp and peel if there is any washing it with water and if
necessary, a mild soap. The whole unit is also dishwasher safe.
• Deep cleaning: all of the components can be removed and can be
cleaned individually. Zumex recommend this type of deep cleaning at
least once a week depending on how much usage the machine gets.
9 Remove the Blade holder (9) and clean it carefully taking care not to hurt
yourself.
EN
33