Accessories - ZUMEX Essential Manual De Usuario

Accessories

There is a wide range of accessories available for you to make the most of your
machine:
1Step Extraction Kit
With this accessory you will be able to dismantle the machine in just 10
seconds and clean it under the tap or in the dishwasher.
Kit S / 1Step Extraction Kit S
To juice fruit that has a diameter of 45 mm to 67 mm.
Countertop Kit
Integrates waste management keeping things practical and clean.
Elevation kit
This Zumex machine has an Elevation Kit to make it easier to clean the
surface where it is located.
Bottle holder
Enables convenient filling of bottles. Suitable for bottles with 38 mm, 36
mm and 34.4 mm necks.
Basket closure and cover
Cover and protect the fruit basket for improved hygiene.
Bottle racks
Dispense bottles, cups or glasses for self-service.
Citric Active
Detergent for food use, formulated to remove pulp and waxes.
Zumex Pack
For packing fresh drinks for sale. There are 4 formats (1 l, 50 cl, 33cl and 25
cl), with a Zumex or customised label.
Consult further information about accessories at www.zumex.com
Detecting Faults
Fault Possible cause
The machine doesn't work Machine not plugged in.
No power is reaching the plug.
Cover not fitted properly.
Juice container not fitted
properly.
Blocked pressing units.
Safety sensors malfunctioning.
Faulty ON/OFF button.
Faulty circuit.
The machine blocks Insufficient voltage.
frequently during juicing
Faulty circuit.
The pressing units are not Fault in an axle.
synchronized
Peel ejector breaks Peel ejector incorrectly fitted.
You can hear the motor
Internal fault.
running but the pressing
units are not turning
EN
Correction
Plug it in.
Check the socket.
Make sure it has been fit
properly.
Make sure it has been fit
properly.
Turn off the machine at the
mains and unblock the pressing
units.
Contact your technical service.
Contact your technical service.
Contact your technical service.
Check that the voltage matches
that indicated in the manual.
Contact your technical service.
Contact your technical service.
Place it in its correct position
inserting it totally until
observing it has madecontact
(Fig. 8)
Contact your technical service.
39