Side Skirt Maintenance - Nilfisk-Advance Adgressor Instrucciones De Uso

SIDE SKIRT MAINTENANCE (DISC SYSTEM)
The side skirt's function is to channel the waste water to the squeegee, helping contain the water within the machines cleaning path. During normal use the
blades will wear in time. The operator will notice a small amount of water leaking out underneath the side skirts. A height adjustment can easily be made to
lower the blades so that all the water can be pick-up by the squeegee.
To reverse or replace the scrub system side skirt(s) ...
1 See Figure 4. Loosen the (2) side skirt Retainer Knobs (A) (2 per side) and pull the Skirt Assemblies (B) off from the scrub deck.
2 Remove all the hardware that holds the blades to the skirt housings.
3 Replace the blades as a set if they are nicked, torn or worn beyond their ability to be adjusted.
4 Reinstall the skirt housing assemblies onto the machine and adjust the blade for proper contact to the fl oor when the brush deck is placed in the scrub
position.
SIDE SKIRT HEIGHT ADJUSTMENT (DISC SYSTEM)
1 The side skirt housing knob retainer screw studs have leveling Adjuster Collars (C), that are to be raised or lowered to compensate for blade wear.
2 To adjust, remove the Skirt Assemblies (B) from the Scrub Deck (D) to access the Adjuster Collars (C). Adjustment Tip: The skirts Retainer Knobs (A)
can be loosened with skirts left on and the Adjuster Collars (C) rotated by reaching under the skirt housing.
3 Turn the Adjuster Collars (C) (Up or Down) to where the blades just fold over enough when scrubbing that all the waste water is contained inside the
skirting. Note: Make small adjustments to obtain good blade wiping. Do not lower the blades too much to where they fold over excessively and cause
unneeded blade wear.
FIGURE 4
FORM NO. 56041988 - Adgressor
ENGLISH / A-15
, Adgressor EcoFlex - A-15
™ ™ ™