Unpacking The Generator; Carton Contents; Install Wheel Kit; Assembly - Craftsman 580.326311 Instrucciones De Uso

Ocultar thumbs Ver también para 580.326311:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Your Craftsman generator requires some assembly and is
ready for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-222-3136.

Unpacking the Generator

1. Set the carton on a rigid flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner from top
to bottom.
4. Leave generator on carton to install wheel kit.

Carton Contents

Check all contents against those listed below:
Main unit
Engine oil
Oil bottle funnel
Operator's manual
Wheel kit
Adapter cord set
If any parts are missing or damaged, call the generator
helpline at 1-800-222-3136.

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use. DO
NOT tow this unit with a motorized vehicle.
You will need the following tools to install these
components:
13mm wrench

ASSEMBLY

Handle Pin
Support Leg
Socket wrench with a 13mm socket
Pliers
Safety glasses
Install the Wheel Kit as Follows:
IMPORTANT: Installing the wheel kit must be completed
prior to adding any oil or fuel.
1. Tip generator so that engine end is up.
2. Slide axle through both mounting brackets.
3. Place a wheel on each side as shown.
4. Place a washer on axle and then place an e-ring in axle
groove.
5. Install e-ring with pliers, squeezing from top of e-ring to
bottom of axle.
E-rings can cause eye injury.
E-rings can spring back and become airborne
when installing or removing.
• Always wear eye protection when installing/removing e-rings.
6. Repeat step 4 and 5 to secure second wheel.
7. Tip generator so that engine side is down.
8.
Attach support leg with M8 x 20 mm cap screws and M8
hex nuts.
9. Return generator to normal operating position (resting
on wheels and support leg).
10. Raise handles and insert handle pins to move generator.
Axle
20 mm Cap Screw
Nut
7
CAUTION
Your unit may vary slightly
from that shown here
Wheel
Flat Washer
E-Ring

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido