Assembly; Install Wheel Kit; Unpacking The Generator; Carton Contents - Briggs & Stratton ELITE Serie Instrucciones De Uso

ASSEMBLY

Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-743-4115. If calling for assistance, please have the
model, revision, and serial number from the data tag available.
See "Know Your Generator" for data tag location.

Unpacking the Generator

1. Set the carton on a rigid flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner from
top to bottom.
4. Leave generator on carton to install wheel kit.

Carton Contents

Check all contents against those listed below:
• Main unit
• Engine oil
• Operator's manual
Figure 1 — Install Wheel Kit
Capscrew
Nut
Handle
Mounting Leg
5500W Portable Generator
• Engine operator's manual
• Wheel kit
If any parts are missing or damaged, call the generator
helpline at 1-800-743-4115.

Install Wheel Kit

The wheel kit is designed to greatly improve the portability
of your generator.
NOTE: Wheel kit is not intended for over-the-road use.
You will need the following tools to install this wheel kit:
• 1/2" or 13mm socket wrench
• 1/2" or 13mm open end wrench
• Pliers
• Safety glasses
Refer to Figure 1 and install the wheel kit as follows:
1. Tip generator so that engine end is up.
2. Slide axle through both mounting brackets.
3. Slide a wheel over the axle.
4. Place a washer on axle and then place an e-ring in axle
groove.
5. Install e-ring with pliers, squeezing from top of e-ring
to bottom of axle.
Axle
Capscrew
Nut
6
Wheel
Washer
E-Ring