Installation - Frigidaire FKGD20ANBLW Manual De Instrucciones

Installation

You can install your gas range on your own based on the instructions described
in this manual.
Unpacking
01. Bring the appliance close to the
installation place.
02. Be careful when unpacking and
installing the appliance. Sharp
edges might cause accidents.
03. Packing material is recyclable.
Separate plastics, from cartoons
and foams to send to each
recycling company.
Installation place conditions
01. The use of gas ranges produces
heat and humidity where installed.
02. Be sure that there is a good air
flow, keeping natural air ventilation
through a window or door or by
installing a range hood to extract
the air. If ventilation is not good,
this might cause lack of oxygen,
that is dangerous for your health
and the gas range performance.
03. If the gas range will be in use for a
long period of time, an extra
ventilation will be necessary to
increase the air flow.
04. Air draft should not decrease the
good performance of the gas
range or cut the gas flame.
05. To install your gas range to an LPG
or NG pipe, check if your house
has a
37
Attention
If replacement of components and/or
accessories is necessary, use original
spare parts only.
gas tap exclusive for the gas
range that is in good condition.
06. Be sure that your house has an
exclusive plug for your gas range
and that it is in good condition.
07 Do not install the range on top of
carpet or rug.
08. Do not install the range near the
refrigerator, as the excessive heat
hinders its yield. For any concerns
see the refrigerator´s manual.
09. If the gas supply will be through a
gas cylinder, and the cylinder is
more than 80 cm from the gas
range, the installation should use
steel and copper pipes according
to your local requirements.
Gas range installation
01. Never use the oven handle to pick
the oven up.
02. After unpacking the gas range,
take out the protector plastic that
protects the stainless steel cook
top. Do not use the gas range with
this protector plastic on it because
it might damage the stainless
steel. Heat will melt the plastic
and make it harder to take it out.
03. Install the burners and pan grill in
its place on the cook top of the
gas range.
04. Leave at least 2cm in the back
and each side of the gas range to
allow the heat to get out.
05. Leave at least 80 to 85 cm
38