Pictgraph Illustration And Explanation - Metabo HPT VB 3616DA Manual De Instrucciones

English

PICTGRAPH ILLUSTRATION AND EXPLANATION

Warning label (Cutting)
Fig. 13
Warning label (Bending)
Fig. 14
Warning label (Battery Cover)
16
Avoid bringing your hand near to the reaction stoppers during operation. If you
do so, you may get your fi nger caught in or may run the hazard of other injuries.
During cutting work, securely hook the rebar to the reaction stoppers.
Furthermore, secure enough length of a rebar to be hooked to the reaction
stoppers.
Never bring your hand close to the cutter during operation.
Continued use of a worn-out cutter can result in the damage and the broken
pieces fl ying around. Replace it with a new cutter after no more than 5,000 times
of cutting.
If the grip rubber gets worn out, there is a fear that it cannot suffi ciently hold the
rebar and gets broken down with its parts fl ying around, etc.
If the grip rubber cannot hold the rebar much longer, replace it with a new grip
rubber. Also replace the worn grip rubber with new one when replacing the
cutter.
Set the rebar in the center or the recess of the cutter during cutting work. Any
cutting work with the rebar set on corners or ends of the cutter can result in
the pieces of broken rebar fl ying around or the damage to the cutter and the
machine.
If you bend the rebar with a large angle while placing your hand onto it, there is a
fear of getting your hand caught in by the fold-back reaction of the rebar.
Begin operation only after ensuring that there are no people within the turning
range of the material to be bent.
Fig. 15
Attach the battery cover when
storing or operating the tool.