Metabo HPT VB 3616DA Manual De Instrucciones página 19

Protective Function
Overload Protection
Overheat Protection
4. About remaining battery indicator
You can check the battery's remaining capacity by
pressing the remaining battery indicator switch to
light the indicator lamp. (Fig. 22, Table 6)
The indicator will shut off approximately 3 seconds
after the remaining battery indicator switch is
pressed.
It is best to use the remaining battery indicator as
a guide since there are slight diff erences such as
ambient temperature and the condition of the battery.
Also, the remaining battery indicator may vary from
those equipped to a tool or charger.
Remaining battery
indicator lamp
Display panel
Lamp Display
Lights 0.1 second. Does not light 0.1 second.
(Fast blinking)
Lights 0.5 second. Does not light 0.5 second.
Remaining battery
indicator switch
Fig. 22
Table 5
Remove the cause of the work overload.
Allow the tool and battery to fully cool down.
State of lamp
Lights ;
The battery remaining power is over
75%.
Lights ;
The battery remaining power is
50% – 75%.
Lights ;
The battery remaining power is
25% – 50%.
Lights ;
The battery remaining power is less
than 25%.
Blinks ;
The battery remaining power is
nearly empty. Recharge the battery
soonest possible
Blinks ;
Output suspended due to high
temperature. Remove the battery
from the tool and allow it to fully cool
down.
Blinks ;
Output suspended due to failure or
malfunction. The problem may be
the battery so please contact your
dealer.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and battery
characteristics, read it as a reference.
NOTE
Do not give a strong shock to the display panel or
break it. It may lead to a trouble.
English
Countermeasure
Table 6
Battery Remaining Power
19