How To Use (Cutting) - Metabo HPT VB 3616DA Manual De Instrucciones

English

HOW TO USE (CUTTING)

WARNING
○ While turning switches, never put your hand
close to the cutter, reaction stopper (A) (B), or
bending roller.
○ Bringing your hand close to these components
can result in serious injury.
○ Confi rm that the hexagon socket bolt attaching
the cutter is tight.
If the tool is used with the bolt loose, it could
damage the tool or the cutter and result in
accident or injury.
○ If the grip rubber is worn, exchange it with a new
article.
When the grip rubber is worn, it becomes
diffi cult to hold a rebar. This could result in
a scatter of mill ends from the rebar. Contact
the metabo HPT Authorized Service Center to
arrange for an exchange of the grip rubber.
1. Inspect the cutter and grip rubber
(1) Position the tool as shown in Fig. 23
Reaction stopper A
Bending roller
Setting dial
(2) Attach battery and battery cover (Fig. 24)
Battery
20
Lever
Reaction stopper B
Fig. 23
Battery Cover
Fig. 24
(3) Turn the lever to the direction indicated by the arrow
and open the cover. (Fig. 25)
Lever
(4) Lower the upper cutter
Lightly pull the switch and slowly move the upper
cutter. When the upper cutter comes outside the cam
cover and the hexagon socket bolt is fully visible,
release the switch to stop it in that position. (Fig. 26)
2 Lower the
upper cutter
Hexagon
socket bolt
Cam cover
(5) Detach the battery cover and battery
Doing so will prevent the switch from being activated
by mistake. (Fig. 27)
Battery
Cover
Open
Fig. 25
1 Lightly pull the switch
Upper cutter
Fig. 26
Battery Cover
Fig. 27