Metabo HPT CJ 18DA Manual De Instrucciones página 15

Insert the splinter guard in the space on the base, and
push it completely. (Fig. 12)
Splinter
guard
8. Sub base (sold separately)
CAUTION
Be sure to switch OFF and disconnect the
battery from body.
Used for curved cutting of pieces such as arcs and
circles. Makes the task easier by eliminating any
snags that may occur between the rear of the base
and the material.
Fit into position after hooking the sub base to the tip
of the base. (Fig. 13)
To detach, pull up.
NOTE
When the sub base is attached, the blade's protrusion
from the material being cut will be reduced by 3 mm.
When the blade has been moved down to the lowest
point, check to make sure that it is protruding from the
material.
Base
Blade
Fig. 12
Sub base
Base
Fig. 13
9. Attaching base plate
Unscrew the four screws on the base to enable the
base plate to be removed.
Retighten the four screws securely after reattaching.
(Fig. 14)
Unscrew four
screws
10. Prepare a work bench (Fig. 15)
Since the blade will extend beyond the lower surface
of the material, place the material on a work bench
when cutting. If a square block is utilized as a work
bench, select level ground to ensure it is properly
stabilized. An unstable work bench will result in
hazardous operation.
Lumber
Work bench
CAUTION
To avoid possible accident, always ensure that
the portion of material remaining after cutting is
securely anchored or held in position.
11. Check battery insertion
WARNING
If the battery is inserted while the power switch
is in the ON position, the power tool will start
operating immediately, inviting serious accident.
CAUTION
Until the battery locks in place with a little click,
if not, it may accidentally fall out of the tool
causing injury to you or someone around you.
English
Base plate
Base
Fig. 14
Base
Blade
Fig. 15
15