DeWalt DCF008 Manual De Instrucciones página 28

ENglIsh
Fig. C
OPERATION

WARNING: Always observe the safety instructions
and applicable regulations.

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Proper Hand Position (Fig. D)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle 8 . Hold tool firmly to control its twisting action.
Fig. D
Angling the Screwdriver (Fig. A, E)

WARNING: To avoid being pinched, hold
the screwdriver as shown in Figure E when
changing positions.
To convert the tool to an angled screwdriver, push in on the
release button and rotate the top portion of the tool until
6
it locks into one of the remaining two positions.
26
Fig. E
1
Torque Control (Fig. F)
The torque adjustment collar
and a drill bit icon. There are 22 clutch settings in all. Each
click in a clockwise direction means an increase in the
torque produced.
To set the torque align the desired setting with the arrow on
the tool housing. The higher the number on the collar, the
higher the torque.
To lock the clutch for heavy fastening operations, move to
the drill bit icon.
If you do not know the appropriate setting to use when
tightening a screw, begin at the lowest torque setting. If
the clutch ratchets before the desired result is achieved,
increase the collar setting and continue tightening the
screw. Repeat until you reach the correct setting.
Fig. F
8
Two Speed Operation (Fig. A)
The dual range feature of your screwdriver allows you to
shift gears for greater versatility.
To select low speed, (high torque setting), turn tool off
and permit to stop. Push the slide switch
on the top of the tool to the left. Use low speed for
screwdriving operations.
To select the high speed, (low torque setting), turn tool off
and permit to stop. Slide gear shifter fully to the right. Use
high speed for drilling operations.
6
2 is marked with numbers
2
4 located