Sveon SNT1022 Manual De Usuario página 38

10.7 CCX
If you have a Cisco Modem or router with this option you will be able to add functions and protections in "Enable CCX"
10..9 Radio On/Off
To enable or disable the searching coverage, select the icon marked with the red line. If you are connected to a network
and you disable this option, you will be disconnected from the network automatically.
10.10 About
This section displays the firmware version, driver and MAC of wireless card.
11. Mac address specifications
In computer networks, the MAC address (Media Access Control) is a identifier with 48bits. It identifies the devices in a net-
work. Each device has its own MAC address and it is setup by IEEE (the last 24 bits) and by the manufacturer (first 24
bits).
The MAC addresses are written directly in binary code ni the hardware of the device.
You don´t have to know the Mac address in the most of situations but i you want to setup your wireless network with MAC
filter, you need to know this address. In the security system, it makes stronger your network because this address is uni-
que. In all the OS, there are different ways to change the MAC address of the connected devices.
The SNT1020 includes its MAC address in a label located in the rear part of the stick as shown in the picture.
SNT1022 User Manual
Index
1. Welcome
2. Features
3. System requirements
4. Technical specifications
5. Content
6. Hardware
7. Driver installation on PC
8. Device connection
8.1 RaUI setup
9. Network connection
9.1 Network connection using WZC
9.2 Network connection using RaUI utility
9.3 Network connection in AP-Mode (Ad Hoc)
9.4 Network connection in 5Ghz frequency
10. RaUI software control panel
10.1 Network
10.2 Profile
10.3 Advance
10.4 Statistics
10.5 WMM
10.6 SSO
10.7 CCX
10.8 Radio On/Off
10.9 About
11. MAC address specifications
Important information
38
English