Test Signals; Rcd Types Tested - Beha-Amprobe Telaris ProInstall-100-EUR Manual Del Usuario

Test Signals

RCD Type
AC
(sinusoidal)
A
(half wave)
B (DC)

RCD Types Tested

Test Function
X ½, 1
X 5
Ramp
Auto
Note:
Mains voltage 100 V – 265 V ac, 50/60 Hz
[1] Type B RCDs require mains voltage range of 195 V – 265 V.
[2] Type AC RCDs only.
Current
*RCD Type
Multiplier
X ½ G
X ½ S
X 1 G
X 1 S
X 5 G
X 5 S
Note:
*G – General, no delay
*S – Time delay
Test Signal Description
The waveform is a sinewave starting at zero crossing, polarity
determined by phase selection (0 ° phase starts with low to
high zero crossing, 180 ° phase starts with high to low zero
crossing). The magnitude of the test current is I
for all tests.
The waveform is a half wave rectified sinewave starting at
zero, polarity determined by phase selection (0 ° phase starts
with low to high zero crossing, 180 ° phase starts with high
to low zero crossing). The magnitude of the test current is
2.0 x I n (rms) x Multiplier for all tests for I
P
magnitude of the test current is 1.4 x I
all tests for all other I
This is a smooth DC current according to EN61557-6 Annex A
10 mA 30 mA
√ √
√ √
√ √
√ √
Measurement Range
Europe
310 ms
510 ms
310 ms
510 ms
50 ms
160 ms
n ratings.
P
RCD Current Selection
[1]
100 mA 300 mA
√ √
√
√ √
√
UK
2000 ms
2000 ms
310 ms
510 ms
50 ms
160 ms
28
n x Multiplier
P
n = 0.01A. The
P
n (rms) x Multiplier for
P
[1] [1]
500 mA 1000 mA
√
√
Trip Time Accuracy
± (2% Reading + 2ms)
± (2% Reading + 2ms)
± (2% Reading + 2ms)
± (2% Reading + 2ms)
± (2% Reading + 2ms)
± (2% Reading + 2ms)
[2]
√
√