GreenWorks ELITE ST-120-T Manual Del Propieratio página 19

OPERATION
2. Remove coil protection from the spool.
3. Remove any remaining line.
4. Clean dirt and debris from all parts. Replace spool if it is worn or damaged.
5. Replace with a pre-wound spool, or replace line using 15 feet (4.6 meters) of 0.065 inch (1.65
mm) diameter line.
W A R N I N G
Never use wire, rope, string, etc., which can break off and become a dangerous projectile.
6. Insert one line into the anchor hole in the upper part of the spool while the other line into the
anchor hole in the bottom part of the spool.
7. Wind the lines clockwise around the spool simultaneously, as shown by the arrows on the
spool.
8. Position the lines in the guide slots.
9. Install the coil protection on the spool. Make sure the end of the cutting line is extended
from the slots of the coil protection.
19
Fig. 10.2
Fig. 10.3
Fig. 10.4
Fig. 10.5