Troubleshooting - Walgreens WGNBPW-210 Manual

TROUBLESHOOTING

If any abnormality arises during use, please check the following points:
SYMPTOMS
Unit does not turn on
when the "START/
STOP" button is
pushed.
E1 error
symbol shown on
display.
E2 error
symbol shown on
display.
E3 error
symbol shown on
display.
E4 error
symbol shown on
display.
EE error
symbol shown on
display.
out error symbol shown
on the display
POSSIBLE CAUSES
Batteries have run down.
Battery polarities have been
positioned incorrectly.
Cuff has been placed
incorrectly or there is an air
circuit abnormality.
Did you talk or move
during measurement?
Shaking of the wrist with the
cuff on.
Pulse signal not detected.
Error determining
measurement data.
System error.
Pressure measurement out
of range.
34
CORRECTION
Replace them with 2 new "AAA"
alkaline batteries.
Re-insert the batteries in the
correct positions.
Wrap the cuff properly so that it is
positioned correctly. Measure again.
Keep wrist steady during
measurement. Measure again.
Measure again.
Relax for 3 minutes, measure
again.
Turn off monitor and measure
again. If EE still appears on
the display followed by any
other character (ex: EE4, EEA,
etc.), please contact Consumer
Relations.
Switch the unit off to clear, then
measure again.