Cleaning, Maintenance And Repair - NovoPress ACO102 Instrucciones De Uso

ACO102
EN
8.3 Performing the pressing operation
CAUTION!
Danger of crushing!
There is a risk that fingers and hands will be crushed.
Therefore:
– Keep body parts and foreign objects away from the press jaws during the pressing
operation.
– Do not hold the jaw levers with your hands during the pressing operation.
CAUTION!
Keep fingers away from the at-risk zone if no press jaw is fitted. (Fig. 4)
Fingers risk being crushed.
Therefore:
– Do not operate the device without the press jaws.
– Keep your fingers away from the at-risk zone.
Information
Comply with the operating instructions for the press tools.
1. Check whether the nominal width of the press fitting corresponds to the nominal width of the press
jaws.
2. Observe the system manufacturer's instructions when fitting the press jaws. (Fig. 8)
Information
Make sure that the press jaw is fully closed when pressing is complete (Fig. 9)
3. To start the process, press the start button.
4. When the pressing operation has been completed
• Detach the press jaw from the press fitting (Fig. 10).
9

Cleaning, maintenance and repair

CAUTION!
Risk of injury during cleaning or repair work from inadvertently pressing the On
switch.
Therefore:
– Comply with the safety instructions and always remove the battery or disconnect the mains
plug before performing cleaning, servicing or repair work.
Service addresses
You can find the addresses of authorised specialist workshops on the "Service addresses" sheet provided
or at www.novopress.de.
Service intervals
Service and repair work may only be carried out by Novopress or the authorised Novopress specialist
workshops.
Information
The next service deadline is indicated on the press device.
This service must be performed at least every 2 years or at the latest when the LED display
indicates that a service is due (see Section
Routine inspection (before use, at the start of the working day) and when soiled
(Fig. 11)
Check for visible damage, material cracks and other signs of wear. If defects are found, do not use the
device and have it repaired.
Six-monthly inspection
Have the device inspected by a qualified electrician or a Novopress workshop.
8.2
Meaning of the LED display).
14