Maintenance Maintenance And Inspection - Hitachi Koki NV 65AH Manual De Instrucciones

Ocultar thumbs Ver también para NV 65AH:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: The information contained in this Manual is designed to assist you in the safe maintenance of the Nailer.
Some illustrations in this Manual may show details or attachments that differ from those on your own Nailer.
MAINTENANCE AND INSPECTION
Read section titled "SAFETY" (pages 4 – 6).
WARNING
Disconnect air hose and remove all nails from
Nailer when:
1) doing maintenance and inspection; and
2) clearing a jam.
1. Clearing a jam
Remove a jammed nail in the following order:
1 DISCONNECT AIR HOSE.
2 Open the nail guide.
3 Insert a rod into the outlet.
Tap the rod with a hammer.
Hammer
outlet
4 Remove the jammed nail with a slotted screw
driver.
Nail
Slotted Screw Driver
5 Cut the deformed collated wire with nippers.
Correct the deformation.
6 In case of frequent jam, contact a Hitachi
authorized service center.
MAINTENANCE
rod
1
Disconnect
air hose
— 15 —
2. Inspecting the push lever
1 DISCONNECT AIR HOSE.
2 Clean the push lever sliding part.
Lubricate it with Hitachi pneumatic tool lubricant.
Nose
Push Lever
Lubricate
3. Inspecting the feeders
1 DISCONNECT AIR HOSE.
2 Clean the knob sliding part.
Lubricate it with Hitachi pneumatic tool lubricant.
Nail Guide
3 Open the nail guide and remove dust.
Lubricate the sliding groove of the feeder and
shafts.
CAUTION
Check that nail stopper (A) and nail stopper (B) slide
smoothly by pusing them with finger.
If not smooth, nails can be driven at an irregular angle
and hurt someone.
English
1
Disconnect
air hose
1
Disconnect
air hose
Knob

Publicidad

Tabla de contenido
loading

Tabla de contenido