Bushnell TROPHY CAM HD ESSENTIAL Manual De Instrucciones página 11

to the SETUP position will turn on the LCD display, and you will see an
information screen that shows how many images have been taken, the
battery level, camera or video mode, etc (see Fig. 3, pg. 12).
NOTE: Always move the power switch from OFF to SETUP mode. It
is possible that the camera could lockup if it is switched from ON to
SETUP mode. If this occurs, simply move the switch to OFF and then
push it up to SETUP again.
SETUP Mode Shortcut Keys/Functions
As mentioned earlier in "Parts & Controls", four of the keys below the LCD
have secondary, "shortcut" functions when the camera is switched to
SETUP mode (but the MENU key has not been pressed):
• Press the UP key to quickly set the camera to shoot video clips.
• Press the DOWN key to quickly set the camera to take still photos.
• Press the RIGHT key to manually trigger the shutter. This is useful
for testing the camera-make sure you are in SETUP mode, press the
RIGHT key, and a few seconds later a photo or video (depending on
how the camera was set) will be saved to the SD card (or internal
memory if no card is inserted). The "number of images taken" counter
on the bottom left of the LCD will increase by one. If the display
indicates "SD PROTECTED" when you press the SHOT key, switch
the camera OFF, remove the SD card and slide its protect switch off.
USING THE SETUP MENU TO CHANGE
SETTINGS
The main purpose of the SETUP mode is to allow you to change the settings
of the camera's parameters (14 different ones are available) so your Trophy
Cam HD Essential operates exactly the way you want it to. You will do this
by entering the SETUP Menu and pressing the keys below the LCD display,
which will show you each parameter and its setting.
Changing Parameter Settings in SETUP Mode
A wide range of options or "parameters" are provided to allow you to set
the Trophy Cam HD Essential to your operational preferences. To change
the setting of any parameter you must first switch to the SETUP mode.
Once in SETUP mode, pressing the MENU button will allow you to select
any parameter and change its setting. The name of the parameter and its
11