Publicidad
Idiomas disponibles
Idiomas disponibles
for the flash to fully recharge before firing again.
d. You can also try setting "NV Shutter" in the menu to "Low"
(slower shutter speed=brighter images, with tradeoff of increased
blur if subject moves rapidly).
e. The ARD (anti-reflective device) shield can be removed to
maximize flash output. See page 25 for more details.
2. Daytime photos or videos appear too dark
a. Make sure that the camera is not aimed at the sun or other
light sources during the day, as this may cause the auto exposure
to produce darker results.
3. Night photos or videos appear too bright
a. You will get the best results when the subject is within the ideal
flash range, no closer than 10' (3m) from the camera. Subjects
may appear too light at closer distances.
4. Daytime photos or videos appear too bright
a. Make sure that the camera is not aimed at the sun or other light
sources during the day.
5. Photos with streaked subject
a. In some cases with low lighting conditions and fast moving
subjects, the 8MP or 12MP resolution settings may not perform
as well as the 3MP setting.
b. If you have multiple images where fast moving subjects produce
streaks on the photo, try the 3MP setting instead.
c. Set "NV Shutter" to "High" to minimize motion blur.
6. Red, green or blue color cast
a. Under certain lighting conditions, the sensor can become
confused resulting in poor color images.
b. If this is seen on a consistent basis, then the sensor may need
servicing. Please contact Bushnell customer service.
7. Short video clips—not recording to the length set
a. Check to make sure that the SD card is not full.
b. Make sure that the camera has good batteries in it. Near the
end of the battery life, the camera may choose to record shorter
video clips to conserve power.
c.
Maximum length of videos captured at night is 15 seconds per clip.
Date/Time Stamp not appearing on images
Make sure that the "Time Stamp" parameter is set to "On".
31
Publicidad
