Controls & Features - Snapper 2691552 Manual Del Operador

Controls & Features
Drive Control
Recoil Starter
Cutting Height
Adjustment
Lever
Side Discharge
Chute
Blade Control
The blade control is attached to the upper handle of the mower.
Depress and squeeze it against the upper handle to operate the
unit. Release it to stop engine and blade.
WARNING:
This blade control is a safety device.
Never attempt to bypass its operations.
Drive Control
The drive control is located on the underside of the upper handle
and is used to engage the drive. Squeeze it against the upper
handle to engage the drive; release it to slow down or stop
mower from propelling.
Cutting Height Adjustment Lever
One adjustment lever is located on the right rear wheel and
one is located on the right front wheel. Both levers have to be
at the same relative position to ensure a uniform cut. To adjust
the cutting height, refer to page 13 in the Assembly & Set-Up
section.
Recoil Starter
The recoil starter is attached to the right upper handle. Stand
behind the unit and pull the recoil starter rope to start the unit.
Blade Control
Oil Fill Cap/Dipstick
Mulch Cover
Figure 4-1
Deck Wash
Your mower's deck is equipped with a fast attach deck wash
nozzle on its surface as part of its deck wash system. Use the
deck wash to rinse grass clippings from the deck's underside.
Grass Catcher
The grass catcher, located at the rear of the mower, is used to bag
the grass clippings for disposal. Once the bag is full, remove it up
through the handles using the grass catcher handle and empty it
before any further mowing.
Side Discharge Chute
Your mower is shipped as a mulcher. To discharge the grass
clippings to the side, follow the instructions on page 12 in the
Assembly & Set-Up section to attach the side discharge chute.
Mulch Plug
The mulch plug is used for mulching purposes. Instead of
collecting grass clippings in a grass catcher or using the side
discharge chute, the mower has the option of recirculating the
clippings back to the lawn. This is called mulching.
Deck Wash
Cutting Height
Adjustment Lever
WARNING:
Keep hands and feet away from the
chute area on cutting deck. Refer to warning label
on the unit.
4
13