Koenic KSH 4220 WD Manual De Instrucciones página 13

Wet shaving
• Wetting your face and apply thin layer
shaving foam to the parts of your face
which shall be shaved.
• Follow steps as given above in chapter
Shaving.
Note
Only proper shaving foam may be used with
the razor, as shaving gel will gum up the
shaving head and impair the result.
Hair trimmer
5
The hair trimmer on the back of the device
allows the cutting of sideburns for example.
• Slide the hair trimmer on the back of the
unit all the way up until it clicks into place.
• Switch on the device with the on/ off
button.
• Carefully guide the hair trimmer to the
ends of the hair to be trimmed and cut the
desired shape.
• After use, switch off the device with the
on/ off button and push the hair trimmer
back down until it clicks into place.
Using the switch lock
• Push and hold the on/off switch for more
than 3 seconds to lock the on/off switch. The
battery and plug symbols will flash three times
and indicate the switch lock is activated.
• To unlock the on/off switch push and hold it
for more than 3 seconds again. The shaver will
switch on automatically. Push the on/off switch
again to switch off the shaver. Connecting the
shaver to the power supply as given in chapter
Preparation will also deactivate the on/off
switch lock.
_KSH4220WD_180803_V07_HR.indb 13
Cleaning and care
Warning
When cleaning, never use solvents or abrasive
materials, hard brushes, metallic or sharp
objects. Solvents are harmful to human health
and can attack plastic parts, while abrasive
cleaning mechanisms and tools may scratch
the surface(s).
• After every use, please use the cleaning
6
brush to thoroughly brush and blow out hair.
• Press the shaving head release on both
sides and remove the shaving head.
• The shaving head can also be rinsed under
running water. But then you have to dry
it well.
• Gently tap or blow out the shaving head.
Use the cleaning brush to clean the two
blade blocks and the housing underneath.
• Place the shaving head on the shaver so
that it clicks in place on both sides.
• Clean the product's exterior surfaces with
a slightly damp cloth and then dry them
thoroughly.
• Make sure that no water enters the
product interior (for example, through the
on/off button). Keep the product in a dry,
cool location which is protected against
moisture and direct sunlight. Keep this
product out of the reach of children.
English
13
3/8/18 5:12 pm