Koenic KSH 4220 WD Manual De Instrucciones página 14

Size - A6
English
Replacing shear foils and blade blocks
The blade blocks are sharp. Avoid injuries by
accidentally touching them.
Assuming the razor is used once a day, we
7
recommend replacing the shear foils and
blade blocks after 1 year.
1. Remove the shaving head as described in
chapter on Cleaning and care (I).
2. Press in one of the lugs on the short sides
of the shear foil holder (II) and push the
shear foil with its holder gradually out of
the shaving head housing (III). Now place
the new shear foil with its holder in the
shaving head housing (IV).
3. Pull the blade blocks upwards and clip the
new blade blocks onto the brackets (V).
4. Attach the shaving head back to the
shaver as described in chapter Cleaning
and care.
Troubleshooting
If there are any problems during operation, please refer to the following table. If problems cannot be
solved as indicated under Solution, please contact your manufacturer.
Problem
Product does not work
LED indicator does not light on
during charging batteries
14
_KSH4220WD_180803_V07_HR.indb 14
Attention
Possible causes
• Interrupted power supply
• Batteries empty
• No power supply
• Charging cord is not connected
Remove the integrated battery
Warning
• Make sure the product is disconnected from
the adaptor before removing the battery.
• Risk of Explosion! Never Replace the
battery.
According to European Battery Directive, the
battery inside the product cannot be disposed
with normal household waste.
1. Remove the screws and take off the enclosure.
2. Cut the battery wires and remove the battery.
to product
Solution
• Check the power supply
• Re-charge batteries
• Check the power supply
• Check the charging cord
connection
3/8/18 5:12 pm