Making Changes With Sound Adjustment Mode - Eclipse CD3000 Manual Del Propietário

Making changes with Sound Adjustment Mode

1
Press the [SOUND] button more than one second.
Enters sound adjustment mode.
2
Turn the [SEL] button to select a setting item.
When the button is turned, the setting item changes in the following order.
Press the [SEL] button to select the setting item. After selecting the setting item, follow
the procedures in the list below.
Crossover adjustment (X-Over F/R)
The HPF (high-pass filter) for front and rear speakers can be switched ON and OFF.
1
Turn the [SEL] button to select ON or OFF.
2
Press the [SEL] button.
ATTENTION: The set value of the HPF is 100 Hz, 18 db/oct.
Crossover adjustment (X-Over NF)
The LPF (low-pass filter) for sub-woofer can be switched ON and OFF.
1
Turn the [SEL] button to select ON or OFF.
2
Press the [SEL] button.
ATTENTION: The set value of the LPF is 80 Hz, 18 db/oct.
Non-Fader phase selection (Non-F Phase)
The merging of sound between the front and rear speakers and the woofer can be improved by selecting the
phase. Switch to a phase which lets the speakers combine without any disharmony.
1
Turn the [SEL] button to select the NORMAL or REVERSE.
2
Press the [SEL] button.
3
Press the [RTN] button.
At this time, other adjustments can also be made in sound adjustment mode.
4
Press the [SOUND] or [RTN] button to exit sound adjustment mode.
How to operate the Sound Adjustment Mode
NORMAL: Normal phase
REVERSE: Reverse phase
X
41